upgrading Camera Process

Discuss Firmware Updates
Post Reply
graemepnz
Airborne
Posts: 17
Joined: Tue Jan 05, 2016 5:24 am

upgrading Camera Process

Post by graemepnz » Sun Dec 25, 2016 1:08 pm

Happy Christmas Everyone.

Can someone please just run me through the process for updating the camera?

This is what I've done - downloaded the file - copied onto SD card and then put into camera and turned the drone on. After an initial quick flash no i've just got a continuous flashing red light on the camera - does this mean it's completed? I don't normally look at the camera when i'm going out to fly so not sure if the red light always flashes?

Many thanks in advance :)
Graeme

pcjones1967
Airborne
Posts: 18
Joined: Sun Nov 06, 2016 11:43 pm

Re: upgrading Camera Process

Post by pcjones1967 » Tue Dec 27, 2016 3:43 am

IT should be completed. Take the card out and read it. If the file you added is gone, you have had success. It erases the file after upgrade.

graemepnz
Airborne
Posts: 17
Joined: Tue Jan 05, 2016 5:24 am

Re: upgrading Camera Process

Post by graemepnz » Fri Dec 30, 2016 3:59 am

So this is what the app tells me my current system is installed with:

Flight Control: 50913
Gimbal 50521
Camera UG3300_C_FW_4.9.1_150804_H

Does that look right? The file hasn't deleted itself off the sd card though?

Cheers

pcjones1967
Airborne
Posts: 18
Joined: Sun Nov 06, 2016 11:43 pm

Re: upgrading Camera Process

Post by pcjones1967 » Fri Jan 20, 2017 6:32 pm

I found that the firmware for the camera that came out before this one did not delete the file. I haven't checked after this upgrade. I will check and comment back

Post Reply