Probably not a calibration issue

Ask for advice with fixing or repairing or custom modifications here.
Post Reply
Feyotter
Posts: 3
Joined: 11 Mar 2016, 16:58

Probably not a calibration issue

Post by Feyotter » 12 Mar 2016, 07:06

Help! I have had my xplorer a week and each time I take it out the first thing I do is calibrate it. Going by the lights it seems to be a successful calibration and the first flight after that seems to prove it by flying beautifully. However, after I land it and then take off again is when the problems start. Just 30 seconds to a minute into the second flight the remote starts vibrating, the drone indicator light on the remote turns red, and the rear lights on the drone turn red. I know it sounds like calibration issues, but why wait until the second flight especially after a seemingly successful calibration just 5 minutes earlier? Any help or advice would be greatly appreciated.

tokepagebang
Posts: 2
Joined: 28 Mar 2016, 09:17

Re: Probably not a calibration issue

Post by tokepagebang » 28 Mar 2016, 09:27

Please calibrate again and make sure you have at least 10 gps signal

baboon99
Airborne
Posts: 43
Joined: 23 Mar 2016, 08:30

Re: Probably not a calibration issue

Post by baboon99 » 29 Mar 2016, 06:35

I get this sometimes. just recalibrate sorts this out.

Post Reply