Hello from PA

Use this place to introduce yourselves and general chit chat
Post Reply
rksix01
Posts: 3
Joined: Tue Jan 03, 2017 4:22 pm

Hello from PA

Post by rksix01 » Tue Jan 03, 2017 4:28 pm

Hello,

I purchased Xiro Explorer V. Have flown it about 5 times, so far so good...

Things I learned:

Do not try to Calibrate the RC with PC Very Very tricky. The Software Sucks!

Firmware: The upgrade Takes a Very long time...be Patient Make sure it finishes.

Other than that, the drone is Joy to fly. I have taken it a few different locations works well. Compass cal seems to work best for me by physically turning my body while holding drone in correct attitude and facing.

I have built a Data logging device that goes in a small box that I print from 3d printer and fits that drone in the Gimbal spot. I collects Temp and Altitude data using BMP180 and Arduino with MicrSD card. I have used this to check the altitude and make sure the drone is operating within parameters. So far so Good.

If you would like one of these for you Xiro PM me and I can get you setup for about $45.00

boobo
Posts: 4
Joined: Sun Jan 15, 2017 6:16 pm

Re: Hello from PA

Post by boobo » Sun Jan 22, 2017 5:31 pm

Very interested in your Data logging device . Email me at jensenterry8@gmail.com please.

Post Reply